• Used
  • New
 
  •  
 
  •  
 
  •  
 

 
2 Results Found for Hogs and Wood Grinders Viewing 1 - 2 of 2 results
STANDARD LISTINGS
PACKER "750" Gasoline Engine Powered, Mobile Waste Grinder: -- Horizontal grinder powered by 123 HP 6-cyclinder Detroit Diesel engine. Grinding and on-site reuse of wood (framing lumber, greenwaste/leaves, etc.), drywall and inert materials such as roofing shingles, block and brick is proving the way to go. -- Self-contained, mobile, low-speed grinder turning waste to cost-effective site resources, such as mulch or erosion control material, soil amendment and road base. -- Easy to operate, mantained and can be pulled by a pick-up. -- Fully hydraulic and very easy to use. -- Equipped with: Remote control; 30" wide conveyor with magnetic head pulley that removes nails and dust suppression. It has the ability to adjust high and low grinder speed from control system, without any mechanical changes. -- Machine has a hopper that measures 26" wide x 72" long x 24" deep (1.1 cubic Yds) and uses a hydraulic ram to push material into the cutter head. Ground material drops out onto an incline conveyor with a magnestic pully head. -- 24'3" L x 8' W overall machine dimensions, Weight: 9800 tLbs.
Equipment Location:NORTHWEST
Jim Reedy
704-841-2001 ext:455
PACKER 750 Gasoline Engine Powered, Mobile Waste Grinder: Horizontal grinder powered by 123 HP 6-cylinder Detroit Diesel engine. -- Grinding and on-site reuse of wood (framing lumber, greenwaste/leaves, etc.), drywall and inert materials such as roofing shingles, block and brick is proving the way to go. -- Self-contained, mobile, low-speed grinder turning waste to cost-effective site resources, such as mulch or erosion control material, soil amendment and road base. -- Easy to operate, mantained and can be pulled by a pick-up. -- Fully hydraulic and very easy to use. -- Equipped with: 30" wide conveyor with magnetic head pulley that removes nails and dust suppression. It has the ability to adjust high and low grinder speed from control system, without any mechanical changes. -- Machine has a hopper that measures 26" wide x 72" long x 24" deep (1.1 cubic Yds) and uses a hydraulic ram to push material into the cutter head. Ground material drops out onto an incline conveyor with a magnetic pulley head. -- 24'3" L x 8' W overall machine dimensions, Weight: 9,800 Lbs. Approximately (1,000) Total operating hours.
Equipment Location:MTN/CENTRAL CDN
Jim Reedy
704-841-2001 ext:455