• Used
  • New
 
  •  
 
  •  
 
  •  
 

 
10 Results Found for Vacuum Pump Viewing 1 - 10 of 10 results
STANDARD LISTINGS
AGILENT / PVR PVL 400 VACUUM PUMP (OIL VANE): -- 15 HP - 1,750 RPM TEFC Direct drive motor, oil-flooded rotary vane vacuum pump with (10) liters or (10.5 Qts. of oil), 29.9 Hg/in at 285 ACFM. -- Pump has an integral oil supply, single-stage with air cooled oil re-circulated by means of differential pressure.
Equipment Location:EASTERN CDN
Norm Schust
800-374-5009 ext:445
BECKER VTLF 400 Vacuum Pump:18 HP Oil-less (Dry) Rotary Vane vacuum pump system, rated @ 280 CFM open flow, max. 22.5" Hg; heavy duty construction, compact design, small foot print. -- 100% Oil-less: Vacuum pump is virtually maintenance free with built-in carbon vanes and built-in suction filters. -- Complete with: Vacuum regulating valve, secondary suction for additional cooling, blow-off valve/silencer, 4" BSP x 4" NPT Nipple; coupled to a 850 RPM TEFC motor.
Equipment Location:NORTHEAST
Norm Schust
800-374-5009 ext:445
BECKER VTLF 400 Vacuum Pump:18 HP Oil-less (Dry) Rotary Vane vacuum pump system, rated @ 280 CFM open flow, max. 22.5" Hg; heavy duty construction, compact design, small foot print. -- 100% Oil-less: Vacuum pump is virtually maintenance free with built-in carbon vanes and built-in suction filters. -- Complete with: Vacuum regulating valve, secondary suction for additional cooling, blow-off valve/silencer, 4" BSP x 4" NPT Nipple; coupled to a 850 RPM TEFC motor.
Equipment Location:NORTHEAST
Norm Schust
800-374-5009 ext:445
DEKKER VMAX 40 HP VACUUM PUMP (LIQUID RING)40 HP oil-sealed liquid ring compact motor-mounted vacuum pump system, 550 CFM, max. 29" Hg. -- Heavy duty construction:Compact design, small foot print, patented, high-efficiency DX-5 separator eliminates oil carry-over concerns.; Engineered for continuous operation -- Extended-lifeSeal-fluid is not used as a lubricant. Change interval is not critical, resulting in a minimum of (10,000) Hrs. of continuous operation. Sturdy bearing pedestal mounts to standard NEMA, C-face motor. -- Direct drive and with Low speed (1,750 RPM) eliminates the use of V-belts, resulting in very low maintenance and zero downtime.Over the full vacuum range without overheating. Air cooled design and low operating noise level.
Equipment Location:EASTERN CDN, AL
EX-FACTORY INC.
704-841-2001
KAESER OMEGA DB235 series 30 HP vacuum blower:513 ACFM, 15"HgV with the speed of 2,860. -- Long service life: Heavy-duty cylinder roller bearings completely absorb the continuously changing radial gas-forces that are exerted on the rotors. Service life of up to 100,000 hours is possible with the included bearings. -- High flow rate = High-efficiency: Thanks to precision manufacturing we achieve minimal flank clearance, which results in reduced capacity losses through gap losses.
Equipment Location:NORTHEAST
Norm Schust
800-374-5009 ext:445
7,5 Kw 10 HP RIETSCHLE VTB-250 Rotary Vane Vacuum Pump:Max. 177 CFM; 1,140 RPM vane speed, generates 150 Torr - 24.0 in mercury; operates at 76 dB. -- Heavy Duty construction, compact design, small footprint; cool, low vibration operation; provides long life & reliability. -- Single-stage pump with an integrated closed-loop oil recirculation system with easy filter changes. -- Low maintaince for this industrial strength Pump designed for 24-hour continuous operation.
Equipment Location:SOUTHEAST
Norm Schust
800-374-5009 ext:445
Spencer Multi-Stage 40 HP Fabricated Centrifugal BlowerLIKE NEW, Never been installed or under powerMachine Specifications: -- 40 HP -- 3500 RPM -- 2250 CFM -- 100 AMPSpencer Multi-Stage 40 HP Fabricated Centrifugal Blower
Equipment Location:NORTHEAST
Norm Schust
800-374-5009 ext:445
TRAVAINI Dynaseal refurbished with (6) months warranty available:40 HP Travaini liquid ring, single stage vacuum pump "TRSC 100-700/C/F". Nominal capacity 500 ACFM @ 20" HgV; max Vacuum 27" HgV. -- Pump materials include.Cast iron housing, ductile iron impeller and stain less steel shaft. Shaft seals are carbon face with viton elastomers. -- 40 HP575 Volt, 3-Phase, 60 Hz, TEFC monoblock assembly for direct drive, no field alignment needed. -- Sealing fluid re-circulating system.includes reservoir of carbon steel with fluid level guage and drain, high efficiency discharge separator and over sized heat exchanger. -- High temp switch,To protect against over temp operation.- Complete with charge of Dynalube fluid. -- Suction line accessories includeinlet check valve, vacuum guage (0 - 30" HgV), inlet filter assembly, manual unloader valve and vacuum relief valve. -- Heat exchangerIs air cooler type made from aluminium and extended surface fins. -- Electrical controls include:Starter/overload reset, pump running light, hour meter, hi-temp light and terminal blocks, all mounted in a NEMA 12 cabinet. -- The entire systemIs test run at the factory for proper operation. -- Note:Electrical control can be changed to 460 Volt @ 52 amps for an additional cost of $900.
Equipment Location:EASTERN CDN
Norm Schust
800-374-5009 ext:445
TRAVAINI TRO 500S-1A 40 HP Liquid Ring vacuum pump 10,230 hours:40 HP Travaini liquid ring, single stage vacuum pump "TRSC 100-700/C/F". Nominal capacity 500 ACFM @ 20" HgV; max Vacuum 27" HgV. -- Pump materials: Include cast iron housing, ductile iron impeller and stain less steel shaft. Shaft seals are carbon face with viton elastomers. -- Power:230/460 Volt, 3-Phase, 60 Hz, TEFC monoblock assembly for direct drive, no field alignment needed. -- Sealing fluid re-circulating system includes reservoir of carbon steel with fluid level guage and drain, high efficiency discharge separator and over sized heat exchanger. -- High temp switch to protect against over temp operation.- Complete with charge of Dynalube fluid. -- Suction line accessories include inlet check valve, vacuum guage (0 - 30" HgV), inlet filter assembly, manual unloader valve and vacuum relief valve. -- Heat exchanger is air cooler type made from aluminium and extended surface fins. -- Electrical controls include: Starter/overload reset, pump running light, hour meter, hi-temp light and terminal blocks, all mounted in a NEMA 12 cabinet. -- The entire system is test run at the factory for proper operation. -- The amps @ 230 Volt = 104; the amps @ 460 Volt = 52 amps.
Equipment Location:SOUTHEAST
Norm Schust
800-374-5009 ext:445
Travaini TRO – 035S – 1A High Efficiency Liquid Ring Vacuum PumpModel: Serial No.: 2897-96Mft Date: 10/96Nominal Capacity ACFM: 35Motor HP: 3Maximum End Vacuum in Hg: 26Approximate Dimensions (in.) L x W x H: 38 x 17 x 40Approximate Weight (lbs.): 340Hours of Operation: ONLY 3,835 (has been in storage most of its life)Needs two seals and glass on one gauge replaced, which seller will have done prior to shipping unit.Manual and other technical information are available upon request.Travaini TRO – 035S – 1A High Efficiency Liquid Ring Vacuum Pump
Equipment Location:GREAT PLAINS
Norm Schust
800-374-5009 ext:445