Original hours, one owner, well maintained, C18 engine and 5 year CAT engine warranty, still running and hours will go up.

1050 HP C27 engine, Morlift 500, 3 flail with bark conveyor. Boom cylinder being repacked, one owner, recent engine work

Rebuilt Deere 600HP engine. Wireless Remote

ONE OWNER, LONG TIME CHIPPING CONTRACTOR REBUILT CAT C27 ENGINE, NEW CLUTCH, RECENT DRUM, FEED DECK, FEED CHAIN, CAN FILL TRAILER IN 11 MINUTES. MUST SEE. WELL MAINTINED, STILL RUNNING IN PRODUCTION STILL RUNNING, HOURS WILL GO UP

Includes Lots of Spare Parts Tidy, Well Taken Care of Machine, Woods Ready.

Mechanically very good Morbark 22RXL Chipper with low original hours (approximately 7500 - manual meter inop). Fitted with CAT 3412 Engine at 800hp, Morbark 75" Disc (4-knife), Morlift 1000 loader, Manual clutch. Runs and chips well with typical wear for age and hours.

Low, original hours unit. 4-Knife, Morlift 1000, End loading chute, C27 Engine at 1050hp, 7800 original hours. Numerous recent service/repairs completed. Quick-change Reimler knife system. Work-ready.

3 flail chipper with 3412 cat engine, Prentice 180D picker, tri-axle, up-graded 3 flail to the H Model orientation. Engine rebuilt with a refurbished cat block, 950 hours since rebuilt. Total reversing flail from cab. Flail speed set mechanically using pump stroke limiters. 65" shiv, hydraulic system with air clutch, babbit knives. Twin disc clutch rebuilt 2000 hours ago. Was used to chip hardwood with a bark content of under 3%. Paddles and anvil replaced in the last 2000 hours. Frame has an estimated 13,000 hours. Well maintained and in good working condition.

Good condition, Woods ready.

CAT 3412 Mechanical Engine, TwinDisc Manual Clutch, Remote Control (throttle, infeed), tandem axle (third axle removed), Flails and flail housings removed, Cab and loader removed. Modifications expertly done. Unit is work-ready.