800-459-2148
713-729-6455
Sawmill Exchange specializes in brokerage of small mills. Thin kerf, circle, scragg and more - when you need a small mill call Sawmill Exchange FIRST!
Industry
BioMass
40 Results Found
800-459-2148
713-729-6455
$15,000
?Blue Star Power System. 550 KW generator with Detroit power. 3 phase. Standby option. 1410 hours. Clean machine.?
$2,000
Buffalo 35" dust blower, all new bearings, banded belt and new 30 HP motor. Marathon motor was bought new with about 20-30 hours.
$3,500
Cat Diesel model D-330. 4 cylinder with turbo, clutch and pony start. Skid mounted. Hours unknown. Runs good. Need to sell!
$5,850
CAT D348 Power Unit - Twin turbos, after cooled, oversized s/s muffler, large 4-section radiator, rebuilt in 2011, 1174 hrs since rebuild, last run 2018, always under cover and CAT maintained. Power unit only. Not a generator.
$19,000
Cummins Diesel engine: Electronic unit 505/8.3 ser# 46485887, model QSC rated HP 260/194 @ 2200rpm. Complete engine with turbo. Engine is new and never run. It was bought as spare for equipment.
$6,500
Cummins 855 Diesel engine. Recently rebuilt with low hours. Has clutch and turbo. Mounted in a frame with wheels. Has water pump and set up as irrigation unit but this can be removed. Needs some work on control panel.
$8,000
Cummins Diesel B 3.3, 85 HP. Has clutch, murphy shut off panel. 0 hours on over haul. Turbo. Skid mounted. Ready to go.
$9,000
Cummins B 378, 140 HP. Clutch, switch panel. Skid mounted. No turbo. 20 hours.
Detroit Diesel, 3 cylinder, clutch assembly. transmission. Used for Frick. Has pulleys and belts. Mounted on metal platform.
$4,000
$3,000
Fulghum 48" 3 knife chipper. Line shaft ready. In good working condition. 24' vibrating conveyor with 5" sides. Sharpener for chipper knives. Custom Built. Wants to sell as package.
7.5 HP High Capacity Blower - GE 3-phase motor, large 5-sided filter area, blower is 12" wide and 32" diameter, crated and appears to never have been put into service. $650.00 each, Two available.
$4,500
International Diesel Engine model 414. 120 HP. Skid mounted. Clutch. No turbo.
$2,000
$12,500
Jackson Shavings Mill. Hydraulic, 50 HP 3 phase electric motor. 2 cutter heads. 3 knives per head. Box is 27" x 54". 6" head.
$5,500
REDUCED TO SELL! $8000. Little Chipper 27-5. 7" wide x 2 1/2" H in feed opening. 10' in feed conveyor belt. Designed to chip scraps from table or rip saws into sawdust. Has hydraulic motor. Like new condition.
$27,000
$35,000
Complete Operation for Grinding Slabs or Pallets: 54" Arasmith Grinder, vibrating conveyor, magnetic conveyor, 150 HP 3 phase electric. Hammermill with 4 screens, blower and auger, 150 HP 3 phase electric.