Description:

NORTHWOOD - NW 3-Axis TA48MT Iron Horse: CNC Machining Center with Roller Hold-down -- SpecificationsAXES TRAVELX Axis: Front-to-back Worktable; 152";.Y Axis: Left-to-right; 105";.Z Axis: Up & down; 14";.AXES TRAVERSE/FEED RATESX-Axis rapid traverse rate: 3,150 IPM (80 MPM).Y-Axis rapid traverse rate: 3,150 IPM (80 MPM).Z-Axis rapid traverse rate: 500 IPM (12 MPM).X-Axis max. machining feed rate: 3,150 IPM (80 MPM)Y-Axis max. machining feed rate: 3,150 IPM (80 MPM).Z-Axis max. machining feed rate: 500 IPM (12 MPM).MACHINE TOLERANCESUnidirectional linear axis positioning accuracy: +/-0.0008";.Unidirectional linear axis positioning repeatability: +/-0.0003";.All tolerances are based on inspection at an ambient temperature of: 68º.Z-AXIS RAM COUNTERBALANCEForce neutral pneumatic counterbalance system with: High volume quick response valves.Vertical Z-axis: Uses a compression nut for max. accuracy and speeds up to 500 IPM.HEAD CONFIGURATION(1) 24 HP, 4-Pole, liquid cooled “cartridge"; spindle “929"; with: HSK F63 Chuck; programmable RPM up to 24,000; synthetic grease lubricated “Quad"; ceramic bearings; safety device for automatic fault detection; max. tool shank diameter: 1";. (1) HSK F63 “12-Station"; Automatic Tool Changer (ATC) Carousel; (2) programmable, lockable Air Blast Nozzles at the spindle; nozzles are programmable via: M code. (1) Dust collection shut/off programmable via: M-code; tool touch-off probe.DRILLING UNIT(1) 5-Line drill unit; each independently programmable; standard 32 mm center spacing.SPOIL BOARD MILLING SOFTWAREAllows input of all parameters necessary for surfacing the spoil board.ROLLER HOLDDOWN(2) “Quad"; Roller Holddown Systems consisting of (4) steel rollers covered with: Engineered poly coating per worktable.Rollers are: Independently programmable via CNC controller to control up & down location. ALUMINUM MATRIX WORKTABLE(1) 49"; x 97"; Cast aluminum high-flow vacuum worktables.3"; Vacuum hoses provide: Vacuum to the worktable.(1) Aluminum matrix vacuum plenums.PART LOCATION STOPS(1) 1-1/4"; Dia. steel part Location Stop is provided; automatic extension & retraction of stop is pneumatically controlled via: M Codes or pushbutton at CNC console. (1) Magnetic sensor switch for part location stop position verification; flush mounted to the edge of the worktable.POP-UP ROLLER BALLS INTEGRATED INTO THE MACHINE WORKTABLE(1) Matrix vacuum plenum equipped with: Pneumatic “pop-up"; roller balls that are integrated into the worktable.Pop-up roller balls assist the Operator in loading & unloading transfer sheets. MATERIAL HANDLING ROLLER TABLES(1) Vacuum sweep dust collection shutoff is controlled via an optic sensor with floating height to move relative to the spoil board thickness automatically.(2) 10"; Blast gates: (1) For the spindle & (1) for the table sweep. Independent safety cables around each material handling table, and the machine “Table will have quick disconnect plugs";