Description:

DOUCET ERS-96/RS-75/AP-508 MULTI-BLADE PANEL GROOVE/RIP SAW SYSTEM:Specifications:• The Doucet ERS-96 / RS-75 / AP-508 Automated Panel GROOVE/RIP Saw System is designed to GROOVE and/or RIP panels as well as edge the sides of core materials. Ideal for plywood, OSB, MDF, HDF and other composite panels. This Line was originally designed for Engineered Flooring Blanks.Material Specifications:• 5x5 and 4x8 material to groove and rip for engineering floor core• Incoming panel thickness: ½" to 5/8"• Incoming panel sizes: nominal 5x5 and 4x8• Grooving pattern at every 4" center across the width of panel• Depth and width of grooves estimated at 3/16" kerf width by 1/8" deep• Ripping patter not mentioned• Maximum weight of stack: approx. 5,000 pounds per stackLine Consists of:• Doucet AP-508 Automatic panel feeder with scissor lift to automatically feed panels as needed• Cross Transfer Chain Conveyor to feed panels sideways by the long edge through the Groover• Doucet ERS-96 Panel Groover • Cross Transfer Chain Conveyor to feed panels short end wise through the panel rip saw• Doucet RS-75 Panel Rip Saw• Outfeed Lift Table to automatically stack ripped strips AP-508 Feed system:• (1) Doucet AP-508 Automatic panel feeder with Indexing scissor lift to automatically feed panels as needed.• (1) Cross Transfer Chain Conveyor to feed panels sideways by the long edge through the Groover, max width 96".• (1) Cross Transfer Chain Conveyor to feed panels short end wise through the panel RIPSAW, max. width 60" • (1) Outfeed Lift Table to automatically stack ripped strips. • 5 HP - 1,750 RPM feed motor, variable feed speed up to 75 FPM.• (4) Powered bottom feed rollers & adjustable top idler pressure rolls with positive panel support during grooving operations.• Top & bottom feed rollers have slip resistant urethane covered rollers, feed rollers are chain driven with air tensioning.• Maximum weight of stack: approx. 5,000 LBS.ERS-96 Panel Groover• 40 HP - 3,500 RPM belt driven saw arbor motor,• Material Width 96"; maximum.• Depth of cut 0.25" - 0.75" (6 - 19 mm) maximum.• 3" dia. Arbor shaft with 1.5 HP motor for motorized arbor adjustment for panel thickness. • Saw arbor accessible from above for tool changes. • 5 HP - 1,750 RPM feed motor, feed speed up to 75 FPMRS-75 Panel Ripper:• 20 HP - 3,500 RPM belt driven saw arbor motor;• Material width cap. 60" maximum.• Strip width cap. 2.5" minimum.• Depth of cut 0.25" - 0.75" (6 - 19 mm) maximum.• 3" dia. Arbor shaft with 1.5 HP motor for motorized arbor adjustment for panel thickness. • Saw arbor accessible from above for tool changes. • 5 HP - 1,750 RPM feed motor, feed speed up to 75 FPMOperator Interface: • Doucet OI/HMI Control System for automatic loading & stacking with minimal human intervention other than a forklift operator to bring in new material and remove the processed parts/strips.Complete with:• Dynamic saw arbor brake;• Infeed anti-kickback fingers;• Saw blade safety interlock cover; •12" dia. du