2003 CENTAURO TA-F-EC AUTOMATIC HYDRAULIC COPY

Nice CF Nielson BP5500 Press. The plant shut down in 2014. The machine was run again for a test in 2016 and everything was in good working condition. They have the dies and pistons to make round and octogonal logs. - Briquetting press CF Nielsen BP5500 - Dies to make 3’’ round logs and 2½’’ octogonal logs - Lignin dosing system - Water pump to add water if material too dry - Home-made automatic speed adjustment with encoder. - Briquette breaker from CF Nielsen at the end of the cooling line - Home-made flying saw with lenght asjustment at the end of the cooling line too with capability to switch from the saw to the breaker. - Can run up to 1200kg (even 1400kg I think) per hour depending on material and briquette shape - Cooling line can be opened to make pucks also. - 575V AC motors - Installed in 2008 - 10,865 hours

Challenger Grinder as pictured

Champion 5 HP 575 Volt 2 Stage 24 CFM unit.

Champion Air Compressor Model HR315-GCC Good Condition

Automatic template Maker for grinding your own Molder knives

15 HP 6500 CFM 10” WC

Siemens Cincinnati HDBI-160 Sawdust Blower Good Condition

Clark Lift 9' Mast Unsure of model number. Plate is worn down. Machine starts and runs.

Clark 6000 lb 60” forks side shift Hard tire

Clean Air Industry Dust Collector 230 /460 volt 3 ph Soft start 30 hp motor Control panel 2- rotary airlocks 18,000 cfm With duct work and fittings. New system Never used

Cleaver Brooks 200 HP Boiler

Cleaver Brooks Boiler 500 HP 4-Pass dryback Propane 60 PSI Design pressure

(3) Available Natural gas fueled 10,461,000 BTU/hour 460 volt 3 phase

12,000 MBTU Natural Gas or Propane Fired New never used (2) Available

Cleereman Carriage PawTawJohn setworks and 3D scanner Three headblock model LPC-42 Four position dogs in/out and bottom dog turning Spare cylinders for all positions Spare top and bottom dogs 30 hp hydraulics

Cleereman #36 Circular Sawmill 100 HP Electric Engine Left Hand

CMC Sawmill Vertical Edger Green Chain Conveyors

This machine is in good working condition and can be inspected under power. Specs (to be confirmed): - Electric spindle 18.1 HP - X-axis stroke 145.66î - Y-axis stroke 82.67î - Z-axis strke 13î - Working area 145.66î x 68.90î - Automatic tilting head - Telescoping spindle extension for surface polishing - (26) ISO 40 tool holders at rear - Bar code reader for program interface

Photos coming Compact DDM6 Profile Canter Line Double Length Infeed Production: 27,000 Logs/ 24 hours, 360 FPM (2x6), 500 FPM 2x4 Infeed belt conveyor V flight scanning conveyor without the scanner and optimization system One pass small log processor Outfeed belt conveyor #1 Outfeed lifting belt conveyor #2 Outfeed belt conveyor #3 Lumber landing table Motor Control Centers (MCC) Programmable Logic Controller (PLC) - obsolete