Biomass Equipment For Sale

HURST - SERIES 45. Boiler: Natural Gas -- SpecificationsBuilt New in 2016; Complete, never installed & ready to deliver! 207.5 HP; 60 PSI Hot Water; Natural Gas Fired Firebox. -- Efficient 3-pass design NATURAL GAS FIREBOX. -- ASME Code constructed & stamped for 15 PSI Stream: 30 - 100 PSI Water. -- Registered with: National Board of Boiler Inspectors. -- Easily maintained, designed for efficiency; large Furnace volume for ultimate combustion efficiency. -- Unified refractory base floor; steel skids; lifting eyes. -- Low heat release; Factory insulated. – 2"; Mineral wool, Factory jacketed & painted. -- Easy access to fireside surfaces; ample waterside clean-out openings -- Fully automatic operation; U.L. listed; forced draft Burners. -- Wet back construction. -- U.L. Listed controls & trim. -- Factory test fired, flame observation ports front & rear.Boiler Design. 3-Pass “FireBox"; design with: Stress relieving “Wetback"; fire tube construction.Hot Water pressures models are from: 8.5 - 415 HP; 100 PSI max.; 500 - 813 HP; 60 PSI max. built to Section-IV ASME Code.Hot water temperature not to exceed 250° F at or near the outlet of Boiler.Hot Water Model Trim. Safety relief valve; operating temperature control; high limit temperature control with manual reset; combination pressure & temperature gauge; low water cutoff control with manual reset.Hot Water Supply. 180 D/F Return: 160 D/F. -- Fireside Heating Surface: 830 Sq/ft. Furnace volume: 132 Cu/ft. Hot water outlet: 8"; hot water drain: 6"; drain connection: 2".Burner: Matched UL listed “forced draft"; power burners with: Factory pre-piped, wired, and tested fuel configurations for natural gas, propane (LP) gas, No. 2 (diesel) oil, or combination of both gas/oil.All units are Factory packaged with: Operating controls, relief valves, burner, and fuel train. Installation is made simple in that only service connections are needed to place in operation.High density 2"; mineral wool insulation assures lower radiant heat loss. In addition to meeting the requirements of U.L., Burner Systems are optionally available to meet the requirements of FM, IRI, Military, and others. -- Actual model: HURST S45 – G – 207.5 – 60W

2012 Hurst Low Pressure, Wood Waste Fired Boiler, 15psi Steam, 30psi Water, 7038 LBS/HR Output, S/N FBI1325-15-15, Includes Expansion Tank, Water Treatment Systems, Electrical, Blowers, Screw Conveyor Feed, Steam Pipes To & including Pipe Manifold, Attached Catwalk & Ladder

Hurst 400 HP Boiler

1989 Hurst Wood Waste Fire Boiler System MDL 710 W/Water Tank Condensate Tank, Infeed Auger, Ash Removal Unit, Controls, 150 PSI, Max WP PSI 975, 5, 175 lbs Steam Per HR & S/N HYB-150-2

HURST 600 HP Waste Fired Boiler; -- Specifications:Complete in-place system with the following features: -- Decommissioned July 2019. -- 150 PSI. (300 PSI max wp), -- 20,700 Lbs per hour. -- Fuel House, Boiler Building and all Controls -- System has been "pickled" to maintain tube integrity.

HUSTLER - FC-2, ...ScreenSpecifications: -- OD at the longest point: 104" -- Long at longest point: 122" -- Tall at the tallest point: 65"Equipped with: -- (2) Shutoff switches

Horizontal bagger Fully automated/computerized control Pneumatic bag folder Pneumatic Heat sealer 2 yard hopper and in feed auger

Hydro-AX 621 Cummins No leaks Mower No cracks or welds 6734 hours 28L tires in good shape Machine is clean

MLS Number 11156730 2019 Jackson Harvester Wood Drying System Lightly used complete wood drying system Three pass system 30' trommel dryer Trommel dryer and stack have been reconditioned Buyer responsible for rigging

50 HP JORDAN - MS4220: Dual Shaft Shredder with Infeed ConveyorSpecifications -- Overall length: 141". -- Overall width: 56". -- Overall height: 98". -- Cutting chamber size: 42" x 20". -- Hopper size: 1-1/2 - 2 Cubic yard. -- Cutter assembly height: 13-1/2". -- Motor horsepower: 50 HP. -- Approx chamber weight: 4,570 Lbs. MS-4220 is a most popular midrange Shredder with: Power to handle tougher jobs; cost that can fit into your demanding budget. MS-4220 can be used to Shred: Paper, plastic, passenger tires, carpet, and an many other materials. Shredder is designed with: Counterrotating dual speed shafts; cutting group continuously changes knife tip position. This helps the knives grab & pull through hard to hold materials. MS-4220 Industrial Shredder offers: Midsize chamber capacity; horsepower to handle many of the most demanding applications. For a cost-effective Shredder, this unit cannot be beat for volume reduction & material shredding. The MS-4220 Industrial Shredder is a "Workhorse."

unused-new, bulk bags, super sacks, bulk totes, FIBC- flexible intermediate bulk container, New-unused-still packaged on original packaging pallets ( bags were manufactured in October 2011 - were stored in warehouse and still stored inside), 35"x 35"x 25" S/S, weight capacity: 2,200 LBS. SWL (1000KGS) safety factor 5:1, single trip FIBC, factory bag drawing is available in photos or upon request, we have approximately 31,000 bulk bags available, bags are packaged 130 bags per pallet- (MINIMUM ORDER IS ONE PALLET: 130 bags at $3.46 each = $449.80 per pallet and will be sold in pallet quantities) , the bag information tags are labeled with the original sellers name: K.C.B. Kansas City Bag Company, document pouch, top filling spout 14” diameter and 19” long, bottom discharge chute 14” diameter and 19” long- with tabbed gusseted liner , liner, reduced price for purchasing large quantities, bags are stored inside on their original pallets with the original covers strapped to the pallets, ocean container loading available - 5200+ bags fit in a 40 ft container, bags are at our location close to ports, Call for pricing and a freight quote or with any questions. Free samples are available upon request - shipped via UPS ground, used semi-automatic bag filling machines with weight check are available- can be used to fill these bags, nationwide deliver is available, call David @360.864.2800 with any questions or for additional photos or delivered prices to your location nationwide or overseas. Estimated freight cost to northern California is 25 cents per bag in truck load quantities, estimated freight cost to southern California is 35 cents per bag in truck load quantities,

Kason 72" Shaker Screener Model K72-1-SS Single Deck 2 HP Mounted on 36" Steel Base Came out Running

KAWASAKI FS030L E Palletizing RobotArticulating arm type Palletizing Robot.Specifications: -- Suction cup type "pickup". -- PENDANT 6 AXIS -- Controller Model "D32FD001" -- Capacity: 30 kG (66 Lbs) bags. -- Complete with pendant control station. -- Includes control panel Cabinet. -- Dimension; 98" H x 42" W x 98" L (wooden crate); weight approx. 3,190 Lbs.Loaded on your truckNOTE: (2) Units available!

KCB BAGS BIG SACKS BULK TOTES "NEW"Bulk Bags, never used. -- Bag size: 35" x 35" x 25" S/S. -- 2,200 Lbs, SWL (1,000 kg), Safety factor 5:1. -- Document pouch. -- Fill spout top inlet. -- Bottom discharge chute with flap, liner. -- Min. purchase quantity is 500 bags. -- Special Price for Higher Quantities -- Loaded on your truck

KEESTRACK - Frontier: Portable ScreenerTechnical Specifications -- Capacity: Up to 600 ton. -- Weight: 30 Ton. -- Screen box (L x W): 4,500 x 1,800 mm. -- Feed hopper in HB450: 8 cbm. -- Hydraulic folding hopper for transport.• Heavy-Duty Plate Apron Feeder: 3,560 x 1,300 mm. -- Loading height. Open back wall: 2,420 mm; half open back wall: 2,850 mm; closed back wall: 3,260 mm. -- Side loading length: 4,400 mm Screen box L x 4,500 W x 1,800 mm Hydraulic liftable screen box.• Screen box can be set in several inclination: Standard walkway beside screen box; Standard Long Life. -- Grease: Interval every (250) Hrs. -- The 1st (2,500) Hrs of its life was used to screen mulch. The rest was used to screen concrete. Needs a starter, but we just wired a direct push button to it. Great shape: Has some surface rust but just cosmetic.New main belt & fines belt in the last (100) Hrs.

2015 Keestrack Frontier 4518 T Scalping Screen, Wireless Remote, Magnet. The Keestrack Frontier Portable Track Screening Plant offers the most superior direct feed screener on the market. With a larger and more aggressive screen box, the Frontier is the right machine for your application. Built to last and designed to perform; the Keestrack Frontier is manufactured heavy duty to work in the most difficult applications. With a larger and more aggressive screen box than others in its class the Frontier will outperform and outlast the competition. With a variable speed apron feeder as standard, it can handle any range of materials. Benefits and Features •Heavy Duty Tracked Scalping Screener •Heavier Duty Construction Than Competitors Machines •Capacity up to 600 TPH (1000TPH on Frontier HP) •10.5 Cubic Yard Feed Hopper •Apron Feeder Standard Heavy Duty Metal Feeder Belt •Wider Standard Screen Deck - 6ft wide x 16ft Long •Double Deck Screen Box With Onboard Conveyors Makes 3 Products •Changing Screens Easier With Screen Box Fully Lifting •Larger Onboard Stockpiling Conveyors •Better Access to the Engine Compartment and Components •Multiple Engine Configurations Available - ECO Option Burns Less Fuel •Load Sensing Hydraulic Drive System - Lower Fuel Consumption •Heavy Duty Danfoss Hydraulic Motors •Tracks System With Two Drive Speeds •Multiple Wireless Remote Control Options With Control Of Functions •Easy To Transport on Standard Lowboy Trailer Perfect For Multiple Applications: Recycling, Topsoil, Mulch, Rock, Sand and more. Disclaimer The information is the best of our knowledge at the time of the listing. The price may change without notice and additional charges may apply, including freight, taxes, duties, tariffs, quarantine, etc.

2013 Komptech Cribus 2800E trommel screen with 4,735 hours. Diesel generator Tier 3 for 480V/60 hz power socket for external power supply 480v/60Hz drums: 1/2" & 1-1/4". Power socket external supply towable, new fines cleated sidewall belt Oct 2020, new belly belt Aug 2020. Operating Weight 35,274 lb Length 34ft 9in Width 8ft 4in Height 13ft 1in Disclaimer The information is the best of our knowledge at the time of the listing. The price may change without notice and additional charges may apply, including freight, taxes, duties, tariffs, quarantine, etc.

2012 Komptech Cribus 2800e Trommel -4735 hours -74hp -1/2 1-1/4 in -7ft 2inch drum -Complete records on machine -Will produce up to 220 yards cube per hour

LAMB 23x27 inch opening grinder with 150 HP motor, 1 3/8” screen and starter control. 460 volt 3-phase

2022 Loftness N38440 G4 Mulcher, Under 50 Hours of Use! Please Call For More Info