Chip Screens For Sale
Category
Chip Screens
19 Results Found
Acrowood Diamond Roll Screener S/N 5533-1 New Never Been Installed7' x 10' supplied with 20. Serial # is 5533-01. The shafts are 80mm diameter with 3mm knurl pattern making it a Particle Screen. Gaps 1-7 have an IRO (Inter-Roll Opening) of 2.0mm using 2mm shims. Gaps 8-15 have a gap of 3mm using a 2mm and 1mm shim and gaps 16-19 have a gap of 4mm using a 2mm, and two 1mm shims. This will pass small to large material as you move down the screen. It was supplied with a Falk shaft mount reducer with telemecanique zero speed switches. It requires a 7 1/2 HP , 1800 RPM motor which was not supplied. It runs at approximately 130 FPM.
BM&M support hangers assemblies, Unused BM&M 773-11/36/4 screen support hangers with bolts still in factory box, photos show both sets of 4 each- (8 hangers available) s/n H177B4146A BM & M U-joint hanger modern style, BM &M screen hanger assembly, BM and M support u joint shafts, unused bmm screen hangers, BMM basket support hangers, stored in our warehouse for prompt delivery. We also have a few used hangers 36 inches long (measured yoke face to yoke face) available, 8 unused and 4 used hangers available ( photos of used hangers available upon request). We have them in inventory for prompt delivery.
$269,000
CAT C4.4 TIER4F DIESEL ENGINE (173HP) 6'4" X 21'2" SCREEN 7.4 CU YD HOPPER CAPACITY RADIAL CONVEYOR W/180 DEGREE SWING AND VARIABLE DISCHARGE HEIGHT 60,500 LB OPERATING WEIGHT TANDEM BRAKING AXLE LOW LEVEL REMOTE GREASING
$7,800
5' x 5' Precision Chip Screen, S/N S1889, Seller will load on your truck (ref #119) Call Rachel 931-797-6284