Equipment For Sale
10575 Results Found
Call for Price
JLG 1930 ES New Batteries Working height7.72 mPlatform length0.76 m Platform width1.87 mTransport length1.87 m Transport width0.76 m Transport height1.52 m Weight1550 kgNet load230 kg Persons2 Travel speed 4.8 km/h Turning radius outside1.75 mmax. climbing ability25 % Platform extension0,9 m Power sourceEEngine manuf.Kohler Engine typeKDI 2504Engine power48 kWMax. torque305/1500 NmNo. of cylinders4
Call for Price
$ 10,000
Call for Price
50 Bin Lumber Sorter, J-bar style, 24' capacity. Right hand. Includes lugged 90 degree turn (clockwise rotation). Down and ready to load.
$ 100,000
End Dogging Scragg 18FT Capacity. 52" blades, 150HP Motors, 18ft 4 strand Log Deck, 2 saw Edger
Cant Optimizer system consisting of: - Built in 1990 - 12" x 24" x 20 foot - USNR Cant Infeed positioning table - USNR Two (2) sided Model 85 canter module with eight (8) knife Key Knife heads,servo positioner and arbor motors (460/3/60) - USNR Profile module with single top and bottom drum style Key Knife profile heads per side with servo positioners and arbor motors (460/3/60) - 6 ft McDonough Twin Bandmill with slide base, servo setworks cylinder and 200 HP, 1200 RPM arbor motors (460/3/60) - Outfeed side board separator c/w center chainway, hold down rolls, cant kicker, spiral roll side board rollcase, pivoting end bumpers and drives - Operators cab and operator's console - PLC control system - Transverse Scanner c/w two (2) banks of seven (7) JoeScan heads - System hydraulic power unit
$ 100,000
Used Chip-N-Saw for logs up to 18" butt diameter. Includes infeed, flying cant turner, canter.
Call for Price
lots of electric motors from 1hp to 300hp , call with your needs, prices range from $10-$15 per hp
$ 4,000
Carriage drive,40 hp electric drive, approx 125 gal reservoir, includes cable drum and motors, good condition
Call for Price
12x70 Triple Pass Drum McConnell Biomass Burner has gas startup: Will need new brick after moved. Includes: Drum trunnions, motors, gear and end caps
$ 850
$ 330,000
13x50 Drum Dryer Has never been used. Only includes the blue shell 2 new forged tires as shown in red on attached sketch No dryer support frame, tire support hardware nor trunnion wheel assemblies c/w drives. Attached drawings were done for a pre planning purpose for installation
Call for Price
Call for Price
$ 7,500
Call for Price
For Printing Extra Large Parts 57" x 44" x 70" capacity High speed printing with (2) printing heads