Stationary Wood Chippers For Sale
Category
Wood Chippers - Stationary
153 Results Found
Call for Price
Call for Price
PHL chipper/ shaker, 6 knives 3 are blocked, includes shaker screen and chip blower, good working condition
48" Precision Chipper with 125 HP motor, top discharge, manual starter, vibrating infeed. Paper plant quality chips. Knife grinder is available, also have a stationary Morbark 5x5-ft rotary chip screen and chip blower.
Complete chip plant includes: - The infeed is 12’ above ground level. They were feeding it one log at a time with a shovel. - There is a single chain 12” wide leading to the debarker. - The debarker is a Salem 20” ring debarker with mcdiarmond controls. - From the debarker it goes through I think is a metal detector. It’s is enclosed, 8’ long with a belt conveyor. - 75’ of 3-strand chain that reduces to 2-strand chain for 35’ then goes to another 2-strand chain for 12’ then goes into the chipper. - The chipper is a Precision with 2- 400 hp high efficiency 3 phase motors. - From the chipper the chips drop onto a 42”x50’ inclined belt that leads to the 2 deck screen. The screen is 92”x20’ - The waste goes on a 9”x20’ incline belt and dropped into a truck. - The chips go out on a 3-strand 100’ conveyor (strands are 14” wide) to a radial stacker for loading trucks. The stacker belt is 42”x65’ - Chips can be redirected to blower unit system that will transport them to a rail siding to so they can be loaded into a rail area. It starts out with 75’ of 12” pipe running on the ground. Then it sweeps straight up to a height of about 24’ and goes 150’ to a siding across the county road. The chip loading facility is intact. - The hog is located back by where the logs are loaded onto the chain going to debarker. Here’s a list of the conveyors going back to the Kockums hog. It has a 24”x36” opening at the top. - Conveyors: 12”x100’, 12”x 25’, 12”x60’. All of these conveyors are 1 strand steel.
Precision 58" Chip Pac 6-Knives 72" Cyclone H-Type blower with dual load out chutes 6'x6' Screen 25' Vibrating Infeed with transition chute to chipper with fiberglass section and MDI metal detector
Call for Price
Call for Price
Call for Price
96" PRECISION Chipper - Serial # C-3096. 1998 model, run only 7 months since new. 8 knife, 8" thick disk, bottom discharge. Out and ready to load. Motor available
96" Precision 4K Left Hand Chipper w/ Andritz Turnknife System installed in good shape. Chipper had over $40,000 of parts installed less than year before removal.
Call for Price
Call for Price
Call for Price
Call for Price
Call for Price
Call for Price
2001 Precision 58" 6 Knife Chip Pack 150HP Elec Motor S/N 3355, 6' x 6' Chip Screen, Cyclone & Pipe S/N S-2375, Precision Dual Trailer Loading System.