600 hp 300 psi Hurst Hybrid boiler system. 1996 year model Equipment Included: 1- 1- Hurst 1996 Hybrid Boiler 2- 1- Hurst woodfire furnace box 3- 1- Hurst 12” metering conveyor system 4- 1- Overfire air combustion fan 5- 1- Underfire air combustion fan 6- 1- Hurst combustion air preheater 7- 2- Hurst multi-cyclone collectors with rotary air lock 8- 1- Flyash Duct 9- 1- Induced draft fan with exhaust stack 10- Access platforms with ladders 11- Boiler and collector system support frame and legs 12- Boiler system control panel (PLC Controller, frequency drives, UDC) 13- Under feed fuel stoker system with cast iron grate system. 14- 20,000 lbs/hr DA Tank with two 15 HP Grunfos Pumps 15- Rear Injection Fan

Hutto Shaving Mill Hydraulic cylinder to hold dow scrap material Infeed shoot: 16" x 30" 30 HP Motor

Hutto Shaving Mill 9' Box (2) Heads 50 HP Motors Outfeed conveyor

12" blade 7-1/2 HP motor 3 phase Foot Pedal control Left Hand machine

Complete operation for sale. Land may also be available. (3) Jackson 8-knife shaving mills Newman 32-knife shaving mill Knife Grinders Shaker Screen Cut Off Saw Briquette System Drum Dryer with Burner and Blower Complete electrical and control (2) Verville VP300 Baggers with bins Shrink wrapper Truck Scales

175 KW -175 KVA 264 amps at 460v John Deere diesel powered 460v - 208v - 115v outlets housed in a container with ample access doors

14@ x 16” inlet 16” Round inlet no motor

(2) McConnell 40-50 MM BTU Gas Burners available

This system was used at an old particle board facility. Seller thinks it is a MEC system. System starts with propane and then runs on dust. Includes burner, blower and piping.

MEC 12'x42' Triple Pass Drum Trunions Cyclone available

MEC 10x40 Single Pass Drum Trunions Controls

225 KVA 480 volt to 208Y/120

Montgomery 100 HP Hammer Mill Includes: Outfeed conveyor and Infeed Hopper

In good condition. Has 50” opening. No drive motor but would take 100-200HP depending on material being run. No screen included. Very heavy weighs approximately 4 ton.

Very clean Newman G-200 Knife grinder. In good working order, grinds 17" on the inside and 20" on the outside.

Nice Newman G-280 tub grinder. Everything functional just needs cleaned.

Nice Newman G-280 that has been refreshed. Has extra cylinder wheels that come with it.

Newman G200 Knife Grinder

These machines were purchased new and removed from the current production line for a large hammermill. Ready to load. No conveyor available. - Newman SS24 - Two machines available. - 100 HP Motor on 600 V. Can be changed to 480 V.

Two Newman Shaving Mills Both mills have 2-heads Already pulled out of service and ready to ship.