Gantry Clearance: 12? Z Axis Travel: 13? Table Size: 4’x8' Working Area: 49?x97? Rapid Speed: 1,800 IPM Cutting Speed: 1,000 IPM Spindle HP: 12HP Spindle Speed: 6,000 – 24,000 RPM Cutting Time: 50 Hours Electrical: 208-230V/ 3PH Equipped With: 12 HP HSD Spindle 8 Position ISO 30 ATC Yaskawa AC Servos Drive Motors 6 Zone Vacuum Table Planetary Gear Box Drive System Tooling Kit Helical Rack & Pinion X/Y Axis Ball Screw Z Axis 10 HP Stock Regenerative Blower Vacuum Pump Syntec Industrial Control System Controller: B+R PP65 Stepper Package Footprint: 78?x127? Approx. Shipping Weight: 3,500 Lbs

Hot Air Edgebander for Preglued banding 0.4 - 1.5 mm thickness Automatic cutoff for up to 1/32" Coil feed with manual feed for strips Panel thickness 10-50mm Front and rear end trim Top/bottom trim

Laguna Bandt 4 Edgebander Machine is 6 months old Extremely low hours - Buyer upgraded to a larger machine!

Model # 01-1172-05-01 60” x 142” table size (1) available no hydraulic units or hand control

Leadermac Moulder 12" Capacity 10-Heads: #1 10 HP, #2 25 HP, #3 25 HP, #4 25 HP, #5 25 HP, #6 30 HP, #7 30 HP, #8 30 HP, #9 30 HP, #10 15 HP 140 FPM with 15 HP feed motor ATS Heads on Top and Sides Second machine available for parts only: Spare castings, gearboxes, pendulums, control panel, spindles

Leadermac LMC-623H Moulder with Infeed Deck This system has not run in year and will need repair.

Leadermac LMC 418-S 4 head moulder 20-80 FPM feed spiral head on bottom 460 volt 3 phase

Lico Rip System with 5-Moving Blades Includes: Infeed, tilt hoist, unscrambler, Lico infeed, 125 HP gang, outfeed tunnel, 75' sort chain Lateral Scanners High speed roller gang with (5) shifting blades: Up to 500 FPM Two Scanmeg scanners Singulating infeed Saw infeed fence Hogging blade to remove inside edging Outside edging falls off and into shredder New system upgrades in 2018

GB-CIS Single-end 575V / 3 Ph / 60 Hz 5” wide rubber pad conveyor Equipped with industrial motor for full power cutting and sanding capacity

Lobo 6-Head Moulder 9" Wide capacity

Year: 2006 Working Width: 25mm to 230mm (1" to 9") Working Thickness: 8mm to 120mm (0.31" to 4.72") Bottom Spindles (x2): 40mm diameter, 0-20mm transverse movement, 6000 RPM, 5.5kW (7.5 HP) Top Spindles (x2): 40mm diameter, 0-20mm transverse movement, 6000 RPM, 7.5kW (10 HP) Side Spindles (x2): 40mm diameter, 0-20mm transverse movement, 6000 RPM, 5.5kW (7.5 HP) Configuration: Bottom, Side, Side, Top, Top, Bottom Feed Motor: 4kW (5.5 HP) Elevation Motor: 0.75kW (1 HP)

Lower Denibbing Sander

Loewer Discmaster 6TD Brush Sander Vacuum Bed