McDonough 54" Resaw Complete Run Around system Controls and electrical Already dismantled and ready to load.

McDonough 54" Resaw Machine was stripped and cleaned, mostly new paint, wheels may need resurfacing (due to sitting).

Meadows sawmill New parts from MFG: Saw Arbor, Live belt conveyor, misc parts Computer setworks 225 HP Detroit Diesel

Meber SR900 Resaw

75 HP Hammermill

MEC 12'x42' Triple Pass Drum Trunions Cyclone available

MEC 10x40 Single Pass Drum Trunions Controls

12x42 Triple Pass Drum Sawdust Burner Controls Cyclone Pipiing Blower

Approx 10 ‘ work area (8) mortise motors Pneumatic hold downs foot pedal controls

Mellott Model 7 Log Turner Hydraulic Power Unit Included

Mellot Husk Frame 18" Belt No Saw or Motor

Mellot Unscrambler

Mellot 3 Strand Log Deck Gear Drive

Mellott Trash Belt With Drive 44' long x 22" wide

Mereen Johnson 431 DC

Mereen Johnson 424 Gang Rip Saw

Mereen-Johnson Model 441-DC Gang Rip Saw Capacity: Arbor space 41” Arbor Drive: 75 HP 3600 RPM TEFC motor Feed Drive: HP TEFC variable speed direct; 45’ to 225’ feet per minute Hold Downs & Bed Plate: Four 5” dia. Air loaded high yield idle press rolls Saw Sleeve: One 41” capacity sleeve Dust Collection: Four upper dust pick-ups: two (2) 8” dia., two(2) 4” dia., one lower 4”dia. Pick-up:(requires total 4820 CFM @ 5,000 feet per minute) Swing Arm & Tip-Up Cart: One floor mounted dual shaft swing arm and one tip-up saw sleeve set-up cart Electrical: Arranged for 3 phase, 60 cycle, 460V Cameron Automated Opti-Rip Model #34F-M1 System: Manufacture Year: (2004) Complete with length measurement Tally System 5 infeed belt and chains for feeding a Gang Rip saw up to 41” wide 16 width sensors 3 sets of pinch rolls for short stock 1 fixed & 4 movable laser lights This system feed for 4’ to 16’ max lumber length It feeds from operator right to left Wired 220V; If 440V required, a transformer will be needed

The seller has confirmed that this Mereen Johnson 441 Rip saw is in great working/running cnodition and it is ready to load! - 2004 Cameron Auto Opti-Rip Infeed - Model: 34F-M1 - Serial: OR164 - 100% Servo (only Servo is this Cameron) - Full amp load 81 - 44" W bed - Up to 20 saws can be run on the arbor - No moving blades BUT there are moving lasers Although this one has been pulled from service, they have an identical one still running and available for inspection....

These two rip saws were removed from service in working condition some time ago. The seller purchased them and never installed them. They have been in storage the whole time.

Mereen Johnson 424 DC Gang Rip Outfeed Rollers