Mereen Johnson 424 DC Gang Rip Outfeed Rollers

These two rip saws were removed from service in working condition some time ago. The seller purchased them and never installed them. They have been in storage the whole time.

The seller has confirmed that this Mereen Johnson 441 Rip saw is in great working/running cnodition and it is ready to load! - 2004 Cameron Auto Opti-Rip Infeed - Model: 34F-M1 - Serial: OR164 - 100% Servo (only Servo is this Cameron) - Full amp load 81 - 44" W bed - Up to 20 saws can be run on the arbor - No moving blades BUT there are moving lasers Although this one has been pulled from service, they have an identical one still running and available for inspection....

Mereen Johnson 424 Gang Rip Saw

Mereen-Johnson Model 441-DC Gang Rip Saw Capacity: Arbor space 41” Arbor Drive: 75 HP 3600 RPM TEFC motor Feed Drive: HP TEFC variable speed direct; 45’ to 225’ feet per minute Hold Downs & Bed Plate: Four 5” dia. Air loaded high yield idle press rolls Saw Sleeve: One 41” capacity sleeve Dust Collection: Four upper dust pick-ups: two (2) 8” dia., two(2) 4” dia., one lower 4”dia. Pick-up:(requires total 4820 CFM @ 5,000 feet per minute) Swing Arm & Tip-Up Cart: One floor mounted dual shaft swing arm and one tip-up saw sleeve set-up cart Electrical: Arranged for 3 phase, 60 cycle, 460V Cameron Automated Opti-Rip Model #34F-M1 System: Manufacture Year: (2004) Complete with length measurement Tally System 5 infeed belt and chains for feeding a Gang Rip saw up to 41” wide 16 width sensors 3 sets of pinch rolls for short stock 1 fixed & 4 movable laser lights This system feed for 4’ to 16’ max lumber length It feeds from operator right to left Wired 220V; If 440V required, a transformer will be needed

225 KVA 480 volt to 208Y/120

Montgomery 100 HP Hammer Mill Includes: Outfeed conveyor and Infeed Hopper

Morgan Splitter Saw

Morgan 4 Head Resaw Very Good Condition

Morgan Single Head Resaw

Morgan Single Head Resaw with Return

Morgan Scragg Mill 40” blades, 50 hp motors, 5 hp hydraulic pack Hydraulic setworks, live deck controls, hydraulic feed and off bearing belts Will cut max 15” diameter and has dogs every 9’ Very low hours with all original belts, etc. 20’ and 33’ scragg decks available

Morgan Scragg Deck 3’ x 21’6” scragg deck Heavy 4 x 8 tubing frame Avg 48” tall Motor and drive Heavy built, low usage, ready to load

Morgan Trim Saw Still on original wrapping. Ready to ship!

Morgan Trim Saw 5' Capacity

Murphy Rogers MRT-12AS Dust Collector

Power Voltage (V) 208-230/460 Frequency (Hz) 60 No of phases 3 Filter type Bag Number of filter elements 24 Filter material Superbag Weight (lbs) 100 Power (Hp) 10.0 (7.5 Kw) Note 5000 CFM at 7.0" Wg All Pipe

New Venture Manufacturing Gang Rip Saw Hydraulic Tank (5) Moving Blades Laser Tower Touchscreen Controls This machine has been removed from service. The photos showing the system setup were taken before it was removed

New York Blower Company Series 20 GI Fan Fan Size 29 DH Good Condition

Newman K20 Trim Saw (2) Blades - Aprox 20" diameter Infeed deck is about 40' long. No chain is included.