Sawmill Equipment For Sale
.gif)
3712 Results Found
Call for Price
$ 100,000
End Dogging Scragg 18FT Capacity. 52" blades, 150HP Motors, 18ft 4 strand Log Deck, 2 saw Edger
Cant Optimizer system consisting of: - Built in 1990 - 12" x 24" x 20 foot - USNR Cant Infeed positioning table - USNR Two (2) sided Model 85 canter module with eight (8) knife Key Knife heads,servo positioner and arbor motors (460/3/60) - USNR Profile module with single top and bottom drum style Key Knife profile heads per side with servo positioners and arbor motors (460/3/60) - 6 ft McDonough Twin Bandmill with slide base, servo setworks cylinder and 200 HP, 1200 RPM arbor motors (460/3/60) - Outfeed side board separator c/w center chainway, hold down rolls, cant kicker, spiral roll side board rollcase, pivoting end bumpers and drives - Operators cab and operator's console - PLC control system - Transverse Scanner c/w two (2) banks of seven (7) JoeScan heads - System hydraulic power unit
$ 100,000
Used Chip-N-Saw for logs up to 18" butt diameter. Includes infeed, flying cant turner, canter.
ACME INDUSTRIAL Blower - 6 blade material handling fan with 12" wide blades on 30" diameter wheel. Inlet 17" diameter. Outlet 14" x 16". Presently has a 10 HP motor but should have 30-40 HP.
ACME Manual Face Grinder for Circle Saws - single phase 120 volt. serial 4829.
$ 180,000
KM-16 HD line with infeed chain deck, Singulator and Auto dealer
50 Bin Lumber Sorter, J-bar style, 24' capacity. Right hand. Includes lugged 90 degree turn (clockwise rotation). Down and ready to load.
$ 8,600
26" wide x 95' long, approx 6" sides, electric drive, good condition
$ 2,000
20" wide x 20' long, 7" sides, electric drive, working condition
$ 250
lumber carts, 42" wide x 7'-12' long, assorted styles and sizes, good condition, (price is per piece),
$ 45,000
.jpg?width=300&height=200&mode=pad)
Shop built Mill with Sawmill System Setworks with air dogs. 12' Carriage. 3 in-feed Log Decks. Morbark 'C' style Debarker. 3hd Block. Crosby 4" Edger with 2 moveable blades. 48" Chippac with Blower. Patz Barn Cleaner/Sweep. Located in MN. #C912
Drag Chain Hopper Feed, Length 148", Width 80", Height 112" Motor and drive
$ 22,000
Sawmill Trimmer - 9 saw, drop saw trimmer, left hand, line shaft design, PLC control, waste conveyor, decline chain deck.
$ 10,000
9' Tall Cyclone, Inlet 13" OD Pipe or 16" Flange. Outlet 17 1/2" ID
Call for Price
Unknown 48" 3K Chipper
Call for Price
Unknown 48" 3K Chipper
$ 6,300
Roberts hammer mill/ waste grinder, top feed, 60 hp electric drive, 3600 rpm's, good working condition
$ 3,450
Aerovent dust blower, 48" dia, 20" inlet- 18" outlet, electric drive, good condition
Call for Price
NEW Gas Kiln 11' x 42' - Sale or Trade
