Sawmill Equipment For Sale
.gif)
3691 Results Found
Call for Price
Call for Price
30' Endwise Log Through Conveyor W/ Chain and Motor and Drive
Call for Price
30HP Hydraulic Power Pack w/Oil Cooler and Electrical Control Box w/Starter
Call for Price
3 Strand Green Chain
Call for Price
12' x 22' 3 Strand Log Transfer (no SNL) Electric Drive.
Call for Price
6'x92" 3-Strand Transfer Deck with 3-Strand Air Jump Up Transfer, 81X Chain, no drive no cylinder
$ 3,000
Call for Price
This wood was all removed from an old mill on South Carolina. It is ready to be loaded out.
$ 2,300
$ 2,750
$ 7,500
15" ladder back chain, 24" pan, 16" sides, 32" x 53' electric drive, good condition
$ 9,750
3" x 13" paddles, 16" pan, 15" sides, electric drive, 20" x 68' long, good condition
$ 2,800
140' of used, heavy duty, #480 drag chain with wings. Rusty, but in real good condition--has been stored outside. 8" Pitch, ultimate strength 102,000 lbs., side bar height 2", overall width 14.5". Chain is in baskets. To be picked up in Biscoe, NC. Chain sold as is /where is. Price $20.00 per foot or $2,800.00 for all the chain.
$ 4,300
40 hp electric, approx 150 gal capacity tank, PVR50 hyd pump, includes all valves attached, very good condition
5 strand, 13' wide x 18' 6" long, H78 chain, electric drive, air cylinders on pop up board stop, good condition
$ 10,750
Model:36EZTD, SN: 42, 5" x 21' tailing belt outfeed, 38" x 9' infeed rolls, 6" x 36" infeed cap, control panel, manual blade set, (2) 20" blades both are adjustable, electric drive, good heavy duty older unit
$ 9,750
4 strand, 33" slats on each strand, electric drive, unit is 80" tall, good condition
$ 5,000
30 HP electric motor w/double pump direct mounter, approx. 100 gal tank, lots of electric control valves, oil cooler, electric control box
$ 195,000
MLS Number 12123201 Small Stud Mill Log deck to feed the Debarker. Max log length 10 ft Max log diameter 18 inch Mainly cut 8 and 9 ft lumber Debarker 18” 6” board edger ( 9 saws moveable hydraulic variable speed) Cut 6” can’t mfg. in 2” material. Can saw 7 x8 cant Max production 25,000 per shift Chip screen 6 x 6 Nicholson Chipper 62” 4 knife horizontal feed Bottom discharge. Twin Scragg 44” diameter saws both moveable Mill is 575-volt 3 phase.
Call for Price
4 Strand 21' Log in feed deck with Stop and Load. Hydraulic drive, 10' wide.