Sawmill Equipment For Sale
.gif)
3838 Results Found
$ 1,700
Rees air lock, 16" inlet/outlet, electric drive, good working condition
$ 6,300
Roberts hammer mill/ waste grinder, top feed, 60 hp electric drive, 3600 rpm's, good working condition
$ 3,450
Aerovent dust blower, 48" dia, 20" inlet- 18" outlet, electric drive, good condition
$ 5,000
roll case with transfer, 26" wide x 11' long, 5 strand pop-up transfer, all mechanical and line shaft ready, like new condition
$ 1,700
dust cyclone 20" dia x 5' tall, 6" inlet, electric drive, includes bag house, good working condition
ACME INDUSTRIAL Blower - 6 blade material handling fan with 12" wide blades on 30" diameter wheel. Inlet 17" diameter. Outlet 14" x 16". Presently has a 10 HP motor but should have 30-40 HP.
ACME Manual Face Grinder for Circle Saws - single phase 120 volt. serial 4829.
$ 180,000
KM-16 HD line with infeed chain deck, Singulator and Auto dealer
50 Bin Lumber Sorter, J-bar style, 24' capacity. Right hand. Includes lugged 90 degree turn (clockwise rotation). Down and ready to load.
Call for Price
Lumber tilt hoist that is ready to be shipped. Specs and dimensions coming!
$ 10,000
9' Tall Cyclone, Inlet 13" OD Pipe or 16" Flange. Outlet 17 1/2" ID
$ 100,000
End Dogging Scragg 18FT Capacity. 52" blades, 150HP Motors, 18ft 4 strand Log Deck, 2 saw Edger
Cant Optimizer system consisting of: - Built in 1990 - 12" x 24" x 20 foot - USNR Cant Infeed positioning table - USNR Two (2) sided Model 85 canter module with eight (8) knife Key Knife heads,servo positioner and arbor motors (460/3/60) - USNR Profile module with single top and bottom drum style Key Knife profile heads per side with servo positioners and arbor motors (460/3/60) - 6 ft McDonough Twin Bandmill with slide base, servo setworks cylinder and 200 HP, 1200 RPM arbor motors (460/3/60) - Outfeed side board separator c/w center chainway, hold down rolls, cant kicker, spiral roll side board rollcase, pivoting end bumpers and drives - Operators cab and operator's console - PLC control system - Transverse Scanner c/w two (2) banks of seven (7) JoeScan heads - System hydraulic power unit
$ 100,000
Used Chip-N-Saw for logs up to 18" butt diameter. Includes infeed, flying cant turner, canter.
Call for Price
12’ x 24” Belt Conveyor with Drive
Blow Hog with Vibrating Infeed Conveyor
Call for Price
Drive Motors, Sprockets/Bearings
Call for Price
Many Head Shafts and Gear/Boxes
Call for Price
Call for Price
 36x4 Strand with Drive.jpg?width=300&height=200&mode=pad)